|
Situated in Beni Khalthoum, 20Kms from the International airport of Monastir, 15Kms from the commercial port of Sousse and 150 Kms from the Capital Tunis, our factory covers an area of 28060 square meters.
This area is divided into workshops, storage rooms, testing laboratories, mechanical testing spaces, administrative rooms and a show room. A total of 150 persons, among them 32 executives and technicians are working in this space.
Our production equipment:
- DAO/CFAO system.
- Laser cut system 3000w BYSTRONIC 3000X1500
- NCC stamping centre AMADA VELA II 2500X1250
- Hydraulic shears 3000X10
- Hydraulic shears 3000X8
- Punching press
- NCC folding press AMADA 80 T 2.5m 8 axes
- NCC folding press AMADA 80 T 2.5m 3 axes
- NCC tube bender PEDRAZOLI 3 axes
- Stamping press 60T-120T
- Cutting press 160T
- Spot welder, MIG-TIG welder, bolt welder
- Industrial painting (Epoxy-Polyester)
Our Now How:
- Laser cutting
- Steel work, boilework
- Welding
- NCC folding
- Industrial painting
Our working process:
Our research and development department deals with all the needs and requirements of our customers and then transform them into 2D and 3D plans.
These plans are transmitted to our production division in order to achieve prototypes. Once approved by the customer the prototype is launched into production.
A planning is established for every production section, and required timing is always respected.
Our quality controllers check the production process from the reception of the raw materials until the finishing and packaging respecting the procedures and international standards.
The delivery service certifies that you will receive your products at the right place wherever you are in the world and our after-sales service offer you different and quick services to ensure the durability of our products.
The whole process is assisted by the computer production management.
|
